DEVICE SETUP
Inside the Shipping Carton
E280 INSTALLATION GUIDE 15
5 Remove the clear protective film from the display.
6 Inspect the device for possible tampering. See how to identify signs of
tampering in section
Periodic Inspection section.
7 Save the shipping carton and packing material for future repacking or moving
of the device.
Periodic Inspection
Periodically inspect the device for possible tampering. Signs of tampering include:
• Overlays in the PIN pad area.
• Wires protruding out of the device.
• Foreign objects inserted into the smart card slot or magnetic stripe slot.
• Any bumps in the casing below the magnetic stripe slot and any noticeable
additional magnetic stripe head from the side.
• Signs of damage to the tamper-evident labels.
• A Tamper Warning message appearing on the device display.
• If any device is found to be tampered, please remove it from service
immediately, keep it available for potential forensics investigation, and notify
your company security officer and your local Verifone representative or service
provider. To contact Verifone, please see
Verifone Service and Support
section.
Do not use a tampered or damaged device. This device comes equipped with
tamper-evident labels. If a label or component appears damaged, please notify
the shipping company and your Verifone service provider immediately.
• Charge the e280/e280s V2 device for eight hours before initial use.
• The e280/e280s V2 device comes with an extra battery, that will power the security
circuit of the device, in case the device is tampered, and the main battery fails to
charge. This extra battery has a life of 2 yrs.
• Ensure not to store the device for more than 1 week without charging, else the
secondary battery gets discharged
in turn reducing the life of the battery.
To Next Page
Loading...
Need help?
General
