DEVICE SETUP
Battery Behavior (No Power Pack)
E280 INSTALLATION GUIDE 17
Battery Features
Following are the features of the battery:
• Single Li-ion cell.
• A safety circuit that:
• Prevents cell damage from overcharge, over-discharge, or overheating.
• Activates when the battery is left in an unused device for extended
periods.
Battery Behavior
(No Power Pack)
The device shifts to power pack mode and starts automatically when the e280
device is connected to a non-battery power source, regardless of the battery
charge state.
Manual Startup
Hold the start button for about 10 seconds until the device displays the startup
screen.
Manual Shutdown
Hold the start button for about 10 seconds until the message is displayed on the
screen. Touch the "Off" selection to turn off.
• Charge the e280/e280s V2 device for eight hours before initial use.
• In case the device is tampered, and the main battery fails to charge, the extra
battery provided with the e280/e280s V2 device will power the security of the
device. This extra battery has a life of 2 yrs.
• Ensure not to store the device for more than 1 week without charging, else
the secondary battery gets discharged in turn reducing the life of the battery.
• Disconnecting and unplugging the device power pack reduces the life of the
coin cell battery which does not recharge and must be replaced if drained.
• Conserve battery power by turning the e280 device off when not in use. Do
not let the battery charge fall below 10% for extended period of time as this
may permanently diminish the battery capacity. Recharge the battery by
attaching the USB-C end of the power pack to the device and plugging the
other end of the power pack into a wall outlet.
Once the device is powered up, Verifone ADK MAC screen is displayed.
The screen is blank when the device has no power.
To Next Page
Loading...
Need help?
General
