NETWORK HOME/OFFICE CONNECTION
IP ADDRESS DISTRIBUTION
The IP Address DistributionIP Address Distribution section is used to configure the
Dynamic Host Configuration Protocol (DHCP) server parameters of
your Fios Router.
Once enabled and configured, the DHCP server automatically
assigns IP addresses to any network devices which are set to
obtain their IP address dynamically.
If DHCP Server is enabled on your Fios Router, configure the
network devices as DHCP Clients. There are 2 basic options in this
section: DisabledDisabled and DHCP ServerDHCP Server.
To set up the Fios Router’s network bridge to function as a DHCP
server:
1. In the IP Address DistributionIP Address Distribution section, select the DHCP DHCP
serverserver. Once enabled, the DHCP server provides automatic
IP assignments (also referred to as IP leases) based on the
preset IP range defined below.
• Start IP AddressStart IP Address – Enter the first IP address in the IP
range that the Fios Router will automatically begin
assigning IP addresses from. Since your Fios Router’s
IP address is 192.168.1.1, the default Start IP Address is
192.168.1.2.
• End IP AddressEnd IP Address – Enter the last IP address in the IP
range that the Fios Router will automatically stop the
IP address allocation at. The maximum end IP address
range that can be entered is 192.168.1.254.
To Next Page
Loading...
