Verizon FiOS - Page 76

76
 / USING NETWORK
CONNECTIONS
verizon.com/business/products/fios-internet | ©2020 Verizon. All Rights Reserved
• Physical AddressPhysical Address - displays the physical address of the
network card used for the network.
• MTUMTU - specifies the largest packet size permitted for
internet transmissions:
– AutomaticAutomatic: sets the MTU (Maximum Transmission Unit
at 1500).
– Automatic by DHCPAutomatic by DHCP: sets the MTU according to the
DHCP connection.
– ManualManual: allows you to manually set the MTU.
COAX LINK
• Privacy - Privacy - to set PrivacyPrivacy, select the EnabledEnabled check box.
This causes all devices connected to the coaxial cable to
use the same password. This is recommended. To set the
password, enter the Coax Link password in the PasswordPassword
field.
• To enable or disable the Coax link, click DisableDisable or EnableEnable.
• To view the devices connected using the coaxial cable,
click the Go to WAN Coax StatusGo to WAN Coax Status link.
• In the Internet ProtocolInternet Protocol section, specify one of the
following:
– No IPv4 AddressNo IPv4 Address: the connection has no IP address.
This is useful if the connection operates under a
bridge.