CAL & ADJUST
3-11
Versapulse Select Service Manual
0621-499-01 03/94
®
®
FIGURE 3.3: USING THE CROSS HAIR APERTURE
FIGURE 3.2 : USING THE TEST APERTURE
Servo Mirror
Remove the channel first relay
mirror mount, then insert the
cross hair aperture in the hole
from the back (further away
from the OC).
CROSS HAIR APERTURE
BURNS THROUGH THE CROSS HAIR APERTURE:
Out in vertical
and horizontal.
Out in vertical Properly
centered
Insert the test aperture
here, in the mounting hole for the
second wedge optic, inserting the
two key posts on the aperture into
the two holes on the mount.
Clear plastic over
burn paper, slides
into slot on the
test aperture.
Towards laser
Towards fiber
Burn paper
To Next Page
Loading...