VXA-300 PILOT III OPERATING MANUAL
8
BEFORE YOU BEGIN
Precautions
This apparatus is capable of two-way communication
on channels used for critical aviation safety commu-
nications. Therefore, it is important that this radio be
kept away from children or other unauthorized users
at all times.
When making DC connections via the (optional)
E-DC-5B/E-DC-6 DC cable, be absolutely certain to
observe the proper voltage level and polarity guidelines.
Do not connect this radio directly to any 24 ~ 28 Volt
DC source, nor to AC power of any kind. Connecting
the VXA-300 directly to a source which exceeds 15.0
Volts DC will result in damage to the unit. The Limited
Warranty for this product does not cover damage caused
by the application of improper voltage.
Do not dispose of the Ni-MH Battery Pack in a fire.
Do not carry a Ni-MH Battery Pack in your pocket,
where keys or coins could short the terminals. This
could create a serious fire/burn danger, and possibly
cause damage to the Ni-MH pack.
Although the VXA-300 is designed to be Submers-
ible (3 ft., 30 min.), its enclosure is not designed to
guarantee protection from ingress of water under ex-
treme pressure. Do not allow the radio to become sub-
merged in deep water, and do not subject it to water
spray under pressure.
Belt Clip Installation
Connect the hanger to the rear of the VXA-300, with
the notch pointing directly up, using the supplied screw
(Figure 1). Use only the screw included with the clip
to mount the clip to the back of the VXA-300.
Clip the Quick-Draw Belt Clip onto your belt (Figure
2).
To install the VXA-300 into the Quick-Draw Belt Clip,
align the hanger with the Quick-Draw Belt Clip, and
slide the VXA-300 into its slot until a click is heard
(Figure 3).
To remove the VXA-300 from the Quick-Draw Belt
Clip, rotate the VXA-300 180 degrees, then slide the
VXA-300 out from the Quick-Draw Belt Clip (Figure
4).
To Next Page
Loading...
Need help?
General
