Chapter 2: Inspection and Site Selection
Inspection
(11/96)
2 Inspection and Site Selection
Inspection
Upon delivery of the 2158, 2160, or 2162 Vertex scale, visually inspect
the scale for any damage which may have occurred during shipment and
handling. Inspect the following areas:
1. Frame assembly for any warpage or bent angles
2. Load cell and suspension assemblies
3. Load cell cables
4. Load cell summing junction box
5. Overall platform assembly
If any damage is noted, contact your freight carrier immediately.
Site Selection
Many problems associated with floor scale installations are caused by
improper site conditions. Before installing the scale, check the proposed
location for the following conditions:
1. Is the area level to within 1/ 4" from the highest to the lowest
corner?
2. Is the floor/support at each corner of the scale area able to
maintain support throughout the entire weighing capacity of the
scale?
3. Is there proper drainage away from the scale area?
4. Are there any heavy vibrations or wind currents present at or near
the scale?
5. Will the scale be subjected to excessive or unusual loading due to
the location or type of equipment used? If the site passes, proceed
with installation. If not, choose a new location or select another
scale.
To Next Page
Loading...