Placing A Call 2-1
Chapter 2: BASIC CALL HANDLING
MBX IP Station User Guide
Chapter 2
BASIC CALL HANDLING
Placing A Call
Internal Calls
You can place calls to other stations in the system over the Intercom. The call will ring, or for
an ICM Voice Announce call, a splash tone will be heard. Ring or Voice Announce is normally
determined by settings at the called station but you may change this by dialing '#' after placing
the call. By changing the mode, a Voice Announce call will ring or a ringing ICM call will allow
Voice Announce (toggle).
You can assign a Flex button for Direct Station Selection/Busy Lamp Field (DSS/BLF). The
DSS/BLF button allows you to call another station with a single button. The button LED will
display the other station's status (ON=busy, OFF=idle).
To place an Intercom call:
1. Lift the handset,
2. Dial the Intercom number of the desired station,
3. When call is answered or Splash tone is heard, begin speaking with the called party.
Using Camp-On when calling a busy station
To Camp-On (wait off-hook) for a busy station:
Press * and wait an answer.
To request a Callback (wait on-hook) for a busy station:
Press the MSG button and hang-up.
To make a Voice Over announcement to a busy station:
Dial #, after the Splash tone is heard, begin speaking.
To Next Page
Loading...
