Using a Bluetooth Wireless Headset (IP-8024 only) B-4
Appendix B: IP PHONES
MBX IP Station User Guide
Using a Bluetooth Wireless Headset (IP-8024 only)
The MBX IP-8024 may be equipped with a Bluetooth Unit (BTU) allowing you to use a wireless
headset that supports Bluetooth version 2.0. Using a headset permits you to move freely
around the phone (within approximately 10 meters) and maintain a conversation. Before using
the headset, the headset must be "paired" with the BTU, and then the headset must be enabled
for use. Operation of the MBX IP-8024 with the headset is the same as with the Speakerphone;
press the [SPEAKER] button to activate the BTU to go ON and OFF-hook.
NOTE: When in pairing mode, the phone and the Bluetooth unit should be within 1 meter proximity.
To pair the wireless headset to the BTU:
1. Press the [HEADSET] button,
2. Dial 2,
3. Press the [HOLD/SAVE] button.
To enable/disable the wireless headset:
1. Set the Bluetooth headset to pairing mode,
2. Press the [TRANS/PGM] button,
3. Dial 63,
4. Dial 1(enable).
5. Press the [HOLD/SAVE] button,
6. Press the NEXT
Soft button,
7. Press the OK
soft button,
8. Enter the PIN code referring to the Bluetooth headset manual (default=0000),
9. Press OK
Soft button.
To unpair the BTU headset:
1. Set the Bluetooth headset to pairing mode,
2. Press the [TRANS/PGM] button,
3. Dial 63,
4. Dial 2 (disable),
5. Press the OK
Soft button.
To Next Page
Loading...
