Using a Bluetooth Wireless Headset (IP-8024 only) B-5
Appendix B: IP PHONES
MBX IP Station User Guide
To check BTU paired information:
1. Press the [TRANS/PGM] button,
2. Dial 63,
3. Dial 3,
4. Press the OK
Soft button.
To use the BTU headset:
1. Press the [SPEAKER] button,
OR
2. Press the "Call Start" button on the BTU headset,
3. Place call as you normally would.
To answer a call with the BTU headset:
1. When an incoming call is received, ringing will be present at the Station and the BT
headset,
2. Press the BT "Call Start" button, or press the [SPEAKER] button,
OR
3. Lift the handset.
NOTE: When the BTU is used for a call, the [SPEAKER] button LED will illuminate and the
speaker mode cannot be used. If the phone handset is taken off-hook while in BT
mode, the voice path will directly be connected to the handset; press the
[SPEAKER] button to activate the BTU headset.
To Next Page
Loading...
