Figure 3.2 Typical Lifting Bar
Method 1
1. Insert the bars into the holes, use the jacks to raise the panel approximately 5 in. to slide the pallet from under the
panel.
2. Place 4 skates in each corner of the split and lower the jacks until the split rests on top of the skates.
3. Remove the bars and then push the panel on the skates to the designated location.
4. Re-insert the bars and raise the split using the jacks then remove the skates and lower the panel onto the
ground.
3 Packaging and Handling Proprietary and Confidential ©2024 Vertiv Group Corp. 15
Vertiv™ UL891 Switchboard Installer/User Guide
To Next Page
Loading...
