Name: Vespa LX 50
Brand: Vespa
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Rear tyre pressure - driver and passenger

2.2 bar

03_05

03_06

Spark plug dismantlement (03_05, 03_06)

Remove cover «A» after unscrewing the corresponding screw. Detach the spark plug

shielded cap and remove the plug with the box-spanner supplied. When refitting the

plug, tighten it manually, being sure to insert it at the right angle; Use the wrench only

to fasten it. Carefully reinsert the screening hood. To reassemble the cover follow the

steps in reverse order, making sure to insert the pins in the lower part of the body.

CAUTION

FOLLOW THESE PROCEDURES VERY CAREFULLY TO AVOID ANY SEVERE

DAMAGE THAT MAY BE CAUSED BY THE VERY POWERFUL IGNITION SYS-

TEM.

CAUTION

THE SPARK PLUG MUST BE REMOVED WHEN THE ENGINE IS COLD.

USING IGNITION ELECTRONIC CENTRAL UNITS OR SPARK PLUGS OTHER

THAN THE TYPES PRESCRIBED (SEE «TECHNICAL DATA» SECTION) CAN

CAUSE SERIOUS DAMAGE TO THE ENGINE.

Characteristic

recommended spark plug:

CHAMPION RN3C

Electrode gap

3 Maintenance

Other manuals for Vespa LX 50

Questions and Answers:

Need help?

Do you have a question about the Vespa LX 50 and is the answer not in the manual?

General