3. Drain up all the vehicle fuel; spread antirust grease on the uncoated metal parts;
keep the wheels off the ground, by resting the chassis on two wooden wedges.
4. For the battery, follow the procedures described in the «Battery» section.
5. Drain the petrol from the carburettor float chamber through the bleed cap.
Recommended products
AGIP CITY HI TEC 4T
Oil to lubricate flexible transmissions (brake, throttle control and mixer, odometer)
Oil for 2-stroke engines: SAE 5W-40, API SL, ACEA A3, JASO MA
Cleaning the vehicle
Use a low pressure jet of water to soften the caked dirt and mud deposited on the
painted surfaces. Once softened, sponge off mud and dirt using a car body sponge
soaked in a car body shampoo and water solution (2-4% of car shampoo in water).
Then rinse with abundant water, and dry with a shammy cloth. For the engine exterior,
use petrol, a brush and clean cloths. Petrol can damage paintwork. Remember that
any polishing with silicone wax must always be preceded by washing.
WARNING
To avoid the appearance of oxidations, wash the vehicle every time it is used in
certain areas or in special conditions of:
· Environmental / seasonal conditions: use of salt, de-icer chemical products on
the road in winter.
· Air pollution: city and/or industrial areas.
· Salinity and humidity of the atmosphere: marine areas, hot and wet weather.
46
To Next Page
Loading...
Need help?
General
