Vetek JIK-6 Series - Installation of Additional Board

Service Manual Indicator JIK-6 Page 12
3-2 Installation of Additional Board
1. First, please open the back cover as per the “Back Cover Assembly and Disassembly” methods.
2. As shown in figure below, mount the additional board onto the main board, and check if every contact is
inserted into the terminal block pin.
(No. A is A/D board module; No. B is solenoid switch and voice function board module; No. C is RS232 modu
le)
3. After the board
s are assembled, insert the fastening stud (J1~J4 as shown in figure below) into the fixing holes as
shown in figure below.
4. After the above step
s are completed, wire with reference to the “Wiring Cross-reference Chart”.
Note: The main board and A/D board are standard equipment (A/D board with dual load cells is optional), all other
components are optional.
(Take the general model with built-in battery as the example)