Service Manual Indicator JIK-6 Page 6
2-2 Advanced Parameter Setting
(1) How to enter and change advanced parameter setting
Step I: When power is on: hold down key for about 3 seconds to enter into [General Parameter], then press
key for about 3 seconds.
Step II: When power is off: press
key to power on and enter into [General Parameter], then press key for
about 3 seconds.
Step III: Select parameter functions by pressing
or key, and select parameter setting by pressing or
key.
Step IV: Press key twice to save the parameter setting, and return to weighing mode. If you
don’t want to save the parameter setting, press key.
(2) Advanced parameter function descriptions
Item Function Display Description
: %
Normal power on to use is allowed
within ±10% (OIML)
: %
Normal power on to use is allowed
within ±20%
: %
Normal power on to use is allowed
within ±30%
: %
Normal power on to use is allowed
within ±40%
A00
Initial Zero Point Range
Overview: The calibrated zero
point value shall serve as the
benchmark, and the zero point
range shall be calculated in
percentage of max. Weighing
value.
: %
Normal power on to use is allowed
within ±50%
: %
A01
Range of Use of Zero Key
Overview: The zero key range
can be improved.
: ~ %
The Zero key can be used for deduction
within ±2%, 3%, 4%… 20% (e.g. ±2% of
300kg= ±6kg)
A02
Return to Zero Symbol-
Display Range
:
Display of zero point symbol when
variation is ±0e (OIML)
To Next Page
Loading...
Need help?
General