Service Manual Indicator JIK-6 Page 4
Chapter II Parameter Function Setting
2-1 General Parameter Setting
(1) How to enter and change general parameter setting
Step I: Power on while holding down key or hold down key for about 3 seconds while power is on with
zero load.
Step II: Select parameter functions by pressing
or key, and select parameter setting by pressing or
key.
Step III: After setting is completed, press key to return to weighing mode.
(2) General parameter function descriptions
Item Function Display Description
: Automatic power-off function off
: Automatic power-off after 5 minutes
: Automatic power-off after 10 minutes
: Automatic power-off after 30 minutes
: Automatic power-off after 60 minutes
PO
Automatic Power-off
Overview: The scale
will be powered off
automatically after
elapse of the set time
when powered on but
not in use.
: Automatic power-off after 90 minutes
:
The internal buzzer makes the beep sound when the
calibration value is within the range.
:
The internal buzzer makes the beep sound when the
calibration value is out of the range.
:
The external buzzer makes the beep sound when the
calibration value is within the range.
P1
Beep
Overview: Select beep
(warning) mode of
buzzer.
:
The external buzzer makes the beep sound when the
calibration value is out of the range.
: Weight value holding function off
P2
Holding the Weight
Value
Overview: The weight
value can be held.
:
Press key to hold the weight value, press
key to cancel.
To Next Page
Loading...