Vetus M2.06 - Page 77

75
6 Maintenance
Cleaning the heat exchanger
61 Replacing heat exchanger
• Replace the heat exchanger in the original
position in the heat exchanger housing.
• Use new O-rings (61 x 2.5 mm) which have
been greased.
• Ret the drain plug.
• Reconnect all hoses previously removed.
• Rell the cooling system, see page 68.
note
Only engines with intercooling!
o-ring, art.Code:
STM6113 (2 x)
62 Replacing the end covers
• Fit the end covers in the housing.
• Tighten up the bolts when both covers are
in the correct position.
STM6202 VD00157