2.Part Description.
Viewing window: This tan acrylic window allows you to monitor the
engraving process, but only partially absorbs the high infrared laser and
has no other protection. Always wear glasses when using the Protective
Observation Active Laser and never stare at it for long periods of time.
LED Light: This light green light illuminates the workbench for a clear
view of the material engraving before, during, and after work.
Y-axis guides: Y-axis guides allow X-axis guides to move back and forth
on the table.
Water cooling switch: After the switch is activated, the built-in water
cooling starts, and the real-time temperature display lights up.
X-Axis Rail: The X-axis rail holds the second mirror and supports the
laser head to move left and right.
Water inlet: This is used to unscrew the lid counterclockwise when filling
the built-in circulating water tank.
Water level display: This observation port can be used to observe the
water level of the water tank in the fuselage. (yellow: too high / green:
suitable / red: too little).
Front Straight Door: This door opens to allow larger materials to pass
through the work bed. Extreme care must be taken to avoid seeing or
To Next Page
