suffering from the laser beam and its reflections. This is also where the
accessory bag was when the engraver first arrived.
Front Access Door: This door provides access to the area below the
bench for easy cleaning.
Canopy: The lid provides access to the main bracket for placing and
retrieving materials, as well as fixing laser path alignment and other
maintenance. When the lid is opened, the power of the laser is
automatically cut off.
Working indicator: It can help the operator to better observe the laser
emission status, red light: laser working, green light: laser idle.
Control Panel: The control panel provides manual control of the
engraving process, including the movement of the manual laser head
and the emission of the laser.
Main switch: control the total power switch of the whole machine.
Z-Axis Control Switches: These buttons move the table up or down to
help you quickly adapt and focus on the various thicknesses of the table.
Connection Ports: These ports connect the main board of the engraving
machine to the control computer and its engrav-ing software via a USB
or Ethernet cable.
Right Access Door: This door provides access to the motherboard, motor
drivers, and power supply. The vents prevent the components from
overheating during use and should not be obstructed.
Motherboard cooling fan: This fan is used for heat dissipation of core
appliances such as built-in motherboards and laser power supplies.
Emergency Stop Switch: In case of emergency, this button will
immediately cut off all power to the laser tube.
Laser Head: The laser head holds the 3rd mirror, focusing lens, red dot
guidance, and air assist outlet.
Table: Table height can be adjusted to accommodate thinner and thicker
materials, as well as between aluminum and cellular platforms.
Laser Control Switch: This switch must be turned on when using a laser.
Light switch: Turn on the light on the workbench.
Rotary axis switch: This switch must be turned on when using the rotary
axis (off when the rotary axis is not in use), if the Y axis is not moving,
To Next Page
Loading...
