5.MATERIAL SAFETY INSTRUCTIONS.
It is the responsibility of the user of this laser engraving machine to
confirm that the material to be processed is able to withstand the heat of
the laser and does not produce any emissions or by-products that are
harmful to nearby people or that violate local or national laws or
regulations. In particular, do not use this equipment to process polyvinyl
chloride (PVC), Teflon, or other halogen-containing materials under any
circumstances.
It is the responsibility of the user of this laser engraving machine to
ensure that everyone present during operation has adequate personal
protective equipment to avoid injuries caused by emissions and
by-products of the material being processed. In addition to the laser
protective glasses mentioned above, this may require goggles, masks or
respirators, gloves, and other protective outerwear.
If the exhaust system is not working properly, do not use this laser
engraving machine under any circumstances. Always ensure that the
exhaust fan is able to remove dust and gases from the engraving
process in accordance with all applicable local and national laws and
regulations. If the exhaust fan or exhaust pipe fails, stop using it
immediately.
Users must be especially careful when working with conductive
materials,as the build-up of dust and environmental particles may
damage electrical components, cause short circuits, or have other
effects, including reflected laser radi-ation.
To Next Page
Loading...
