This machine is safe to use with the following materials:
1.plastics.
·Acrylonitrile butadiene styrene (ABS)
·Nylon (polyamide, PA, etc.)
·polyethylene
·High-density polyethylene (high-density polyethylene, polyethylene,
etc.)
·Biaxially oriented polyethylene terephthalate (BoPET, polyester,
polyester, etc.)
·Polyethylene terephthalate (PETG, PET-G, etc.)
·Polyimide (PI, Kapton, etc.)
·Polymethyl methacrylate (PMMA, acrylic, plexiglass, fluorite, etc.)
·Polyoxymethylene (POM, acetal, DL, etc.)
·Polypropylene (PP, etc.)
·styrene
2.other.
·cardboard
·Ceramics, including cutlery, tiles, etc.
·glass
·leather
·Paper and cardboard
·rubber
·Stone, including marble, granite, etc.
·Textiles, including cotton, suede, felt, hemp, etc.
·Timber, including cork, MDF, plywood, balsa wood, birch, cherry, oak,
poplar, etc.
Note:See for the recommended parameters for the most commonly used
engraving materials.
To Next Page
Loading...
