Refer to Usage Data.
IT IS RECOMMENDED TO SET THE POWER TO 80
Laser power 90％: Acrylic cutting should pay attention to air flow control, the surface of the material blowing should be small or
side-blowing, which can ensure the smoothness of acrylic, and the acrylic surface should have air circulation to prevent fire
Laser power 90％: Wood cutting mainly controls the airflow, the larger the airflow, the faster the cutting speed
It is recommended to use a focusing lens with a focal length of 50.8,with a laser tube of 60W-100W and a small
amount of air compressor,it is recommended to cut at 50%-70%power.
BI-color plate and PVC cutting parameters,paper-cutting should pay attention to laser power adjustment,the higher
the laser tube power,the smaller the percentage of laser power adjustment
To Next Page
Loading...
