EasyManua.ls Logo

VEVOR LB175A - Condenser Cleaning and Reassembly; Condenser Cleaning Precautions; Condenser Cleaning Process; Reassembly After Cleaning

VEVOR LB175A
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Safety Tips
Number: JT190199990 Version Number: A1
Note: Subsequent versions of this specification are subject to change without prior notice. Thank you
12/23
Cleaning and disinfection
13.4 Condenser cleaning
Warning
Clean condenser, must disconnect ice
machine power supply. Condenser edge
sharp, clean carefully cut.
attention
It is strictly forbidden to wash the ice
machine with water sprayer. Do not use
any alcoholic liquid to clean or disinfect the
ice maker, otherwise it may cause cracks
in plastic parts;
Remove the roof and back panel, and
should be removed by maintenance
personnel with relevant knowledge;
Do not wash plastic parts in water or
dishwasher above 40℃ temperature to
avoid damage to parts.
It is recommended that the condenser be
cleaned every six months, following the
following steps:
Use cross screws to remove the left and right
sides of the ventilation window, remove the
ventilation window;
Pull up the filter on the ventilation
window
Use nylon brush filter to remove dust;
Brush condenser fin dust with nylon brush
along the upper and lower direction;
important
After cleaning, please install back the top cover
plate, back plate, correct installation cooperation.

Related product manuals