VEVOR LB175A - Parts Removal and Reassembly Guidance; Pipe Reassembly Alignment; Baffle Removal and Reinstallation

Safety Tips
Number: JT190199990 Version Number: A1
Note: Subsequent versions of this specification are subject to change without prior notice. Thank you
17/23
Cleaning and disinfection
Unplug pipe
b．Remove two screws
Spin out the plastic cover and remove the
plastic mandrel
Note: when the pipe is assembled, the pipe hole
position and mandrel hole position direction
should be opposite, must not be the same
direction, the correct diagram is as
follows:
c． Disassemble and assemble the baffle: grasp
the middle position of the baffle and use a flat
screwdriver to force from one side to the other
until one side of the baffle is removed from the
pin hole.