3. Cleaning the spray water pipe
A、Cleaning the ice maker:
The spray water pipe must be cleaned once per half
a year. When you clean it, firstly open the front cover,
take out the spray pipe, and then scour off the scum
till the every hole is unblocked. Reinstalled it after
finish cleaning.
C、After finishing washing，screw out the cap of
the drain-valve and drain out all the dirty water,
then tighten the cap。
C、After finishing washing，screw out the cap of the drain-valve and drain out
all the dirty water, then tighten the cap.
4. Automatically cleaning of the ice maker
Automatically cleaning the ice maker: when the machine is making ice, softly push
the “clean” key on the electrical box, which is on the rear panel, the refrigeration
system will stop working, and the machine turn into an auto-wash process. The
wash process is divided into three steps: wash, potch, and drain. It will cost bout
30 minutes. To improve the cleaning effect, the user can add a little neutral
detergent, and after finishing washing, the machine turns into ice-make condition
automatically.
5. Clean the split type commercial ice maker and auto-clean series ice maker.
Button “AN(MODE)” on the PC board: After pressing the button “AN(MODE)”, the
machine will stop current working process and turns into next.
Working process: power supply——filling
water——balance——pre-cooling——refrigerating——collecting ice——ice is full
Switch on the power source and clean
A、Usually, the machine is connected to the power source continually. When you
connect the machine to the power source firstly, there is a clean process after the
water in the sink is full: water supply——water pump works ——water pump works
and drain-valve opens——water supply——water pump works——water pump
works and drain-valve opens——pressure balances. This process will take about 5
minutes(once every 30 ice-make cycles). In addition, after every four ice-make
cycles, there is a draining process, draining out the water in the sink.
To Next Page
Loading...
