B、After finishing washing, confirm the place of the float ball: If the float ball is on
the bottom and the machine is on, this condition is normal, the program will turn
into pressure balance process, the water level will be controlled automatically; If
the float ball is on the upper position and the machine stops, it means that there
are some problems with the water level sensor, water pump or drain valve.
Point：the water-filter core is consumable, it is not in the guaranteed scope. If you
need it, please contact with our marketing department and buy it.
Please according to the following steps if you haven’t used the machine for a long
time.Turn off the power switch, remove the machine's plug, then cut off the power
supply and water supply.
B、Take out the ice block from the cabinet, wipe out the water on the inner of the
cabinet.
C、Wipe out the water on the cabinet, then open the door and dry the cabinet.
The electric wire didn’t
connect well.
The retained board was
pinned by ice block.
Take out the ice block so
as to let the retained board
return to the original
situation.
The connecting wire of
compressor’s starter is loose
The starting capacitor of
compressor is broken
Water level sensor is broken
Water supply solenoid valve is
To Next Page
Loading...
