Ensure that the UV lamp is always in the closed position (arrow on the lamp base
matches the position of the closed lock on the lamp socket) before switching on the
UV lamp.
6.8 Electrical installation
Making changes to the UV system is not permitted.
For the installation of the UV system and therefore also the control system, follow
the guidelines described in the chapter 'Environmental conditions'.
Also follow the instruction as described in the 'Safety instructions' chapter to work
safely.
Ensure that the grounding cable, which is already connected to the control, is
connected to the relevant and marked ground wire end on the irradiation chamber
before the UV system is put into use. Check whether the irradiation chamber has a
good electrical connection with the ground contact in the plug.
The UV system is supplied with a permanently connected power cord with plug, this must be connected to a
wall socket with protective ground. For this, also follow the mains voltage specifications as specified in the
'Mains voltage' chapter.
To Next Page
Loading...