16
Safety
Be careful when cleaning with high pressure cleaner
Only clean bearings, hydraulic hoses, plastic components, electrical
control boxes and electrical equipment with low water pressure.
By cleaning with low water pressure you will protect sensitive
equipment on the machine.
Cleaning with high water pressure could damage vital parts of the
machine.
Disconnect the battery and the alternator before welding
The tractor battery and alternator should be disconnected before
welding work is carried out on the machine.
This will protect the tractor alternator during welding work.
The tractor alternator could be damaged or destroyed if the electric
connections are not disconnected before performing welding work.
Tighten all fittings on moving parts
Check that bolts on moving parts are tightened after performing
maintenance work.
Tightened parts prevent jarring sounds from moving parts.
If parts are not correctly tightened, they can shake loose and can
cause damage to the machine.
Do not alter the machine construction
The technical construction of the machine should not be altered and
machine maintenance should be performed.
A well maintained machine will offer maximum protection.
A poorly maintained machine will not offer proper protection and could
be dangerous.
95-018
To Next Page
Loading...
