Operation
53
T
IP
!
The recommended distance between the rollers is 3 mm.
The distance between rollers is checked in the following way:
T
IP
!
It is recommended that the check be carried out by 2 operatives.
> Place a 3 mm spacer in between the rollers, approximately 50 mm
from the outermost end of the roller on both the left and right-hand
sides.
> Turn the rollers a little so that the spacers are placed in between
the rollers.
> check that the rollers are correctly positioned pressed against the
spacers.
• If there is too much distance between the rollers:
»Reducing the distance between rollers« page 52
• If there is too little distance between the rollers:
»Increasing the distance between rollers« page 54
> Tighten the counter nuts.
To Next Page
