80
Maintenance
Service - check
Safety concerning maintenance work with the transmission
When working on the transmission the tractor must be stopped and
secured.
This prevents the machine from suddenly starting to rotate.
If the tractor and the PTO shaft have not been connected following the
instructions, serious accidents causing damage to limbs can occur.
When working on the transmission:
• The tractor engine must be stopped.
• The ignition key must be removed.
• The PTO shaft must be disconnected.
• The tractor hydraulic system should be disconnected.
• The hand brake should be activated.
Cutterbar
Be careful when using oil
Use protective cream or protective gloves when handling oil.
It will protect your hands against skin injuries.
Direct contact with the oil could lead to serious skin injuries.
Use the correct oil type
Always use the correct oil type for the transmission.
This ensures a long lifetime for the transmission.
Use of incorrect oil type may lead to damage of the transmission.
Maintain correct oil level
Max. and min. indication for oil level on the transmission must not be
exceeded.
Correct oil level of the transmission ensures a long lifetime.
Wrong oil levels can cause heat development in the transmission,
resulting in serious damage.
Checking the oil level
Every day
Inspection of the oil level for the cutterbar is carried out as follows:
> Place the machine on a level surface.
> Lower the cutterbar to the ground.
> Check the position of the cutterbar with a spirit level and, if needed,
adjust its position with a wooden block.
!
To Next Page
Loading...
