Maintenance
132
Accumulator
Very high amount of accumulated pressure in the accumulator
Do not attempt to take the accumulator apart.
The accumulator contains very high accumulated pressure and may
only be taken apart by authorised persons.
Attempting to take the accumulator apart can lead to serious or fatal
injury.
Every season
The machine is fitted with an accumulator that can absorb excess
shock from the cutting unit when the machine is in its transport
position.
Pressure in the accumulator: 145 bar (2105 psi).
The check may only be undertaken by authorised persons.
Wheel
After 10 hours of use
Thereafter, every season
»Maintenance intervals« Page 84
Use a suitable torque wrench adjusted to the torque shown in the
table below.
Place the wrench on the wheel bolts.
Check all the bolts on the wheels and tighten them to the torque
shown.
Check the tyre pressure and, if necessary, top up the tyre to the
pressure shown in the table below.
Model: Tyre
Dimension
Tyre pressure
bar (psi)
Bolt torque
Nm (ft/lb)
832-35R-832CR Pro 15.0/55 -17 2,6 (37) 300 (220)
To Next Page
Loading...
