Maintenance
83
General instruc-
tions
These instructions concern general maintenance work. Specific
maintenance work procedures for each machine will be described
later. When performing any maintenance work the machine must be
secured in the transport position. If the work position is necessary for
performing maintenance work, you will find appropriate instructions to
cover this.
Working with the grease gun
One or two pumps of the grease gun is sufficient for lubrication. If you
feel resistance after just one pump on the lubricant spray, do not apply
more grease to the bearings. When too much grease is applied,
bearings drift apart. This can result in dust and dirt entering the
bearings and causing premature wear and tear.
Basic
This table contains explanations of the most important maintenance
terms.
Work Performance
Lubricating with oil can
Add oil from the can to the moving parts
Use only authorised products
»Technical information« Page 177
Lubricating with grease
gun
1-2 pumps with the grease gun is sufficient unless otherwise stated. Use only
authorised products
»Technical information« Page 177
Oil change
Use only authorised oil products. Using used oil is dangerous for your health and
is strictly prohibited
»Technical information« Page 177
Replace
Replace the appropriate part following the instructions given in the "Replacement"
chapter
»Replacement« Page 133
Check
Check the appropriate part following the instructions given in the "Service - check"
chapter
The check is sometimes related to the replacement of the part in question
»Service - check« Page 94
Complying with the
maintenance intervals
All specifications are based on an average usage of the machine. If heavily loaded,
e.g. machine pool, maintenance should be carried out on a more regular basis. In
work conditions producing high levels of dust, maintenance should also be carried
out on a more regular basis
To Next Page
Loading...
