Maintenance
140
CR model
The oil is changed as follows:
Remove the guard.
Use a suitable tool to remove the oilplug.
Let the oil flow into a suitable container.
Allow the last of the oil to drip out of the transmission for approx.
10 - 15 minutes.
Fit the oilplug and tighten it.
Remove the dipstick.
Pour the new oil through the hole where the dipstick is fitted.
Fit the dipstick onto the transmission, then remove it again.
Check that the oil level is up to the “max” indication on the dipstick.
Repeat the procedure until the correct oil level is reached.
The oil level on the main gear must always be between “min.” and
“max.” as shown on the dipstick.
»Lubricants« Page 177
To Next Page
Loading...
