Operation
60
Changing the roller
pressure
The setting for the springs must be exactly the same on both sides of
the machine.
The roller pressure is adjusted in the following way:
Left-hand side:
Use the appropriate tools to loosen the counter nut shown, which
is located close to the springs.
Position a tool on the tightening surface of the spring.
Position a tool on the tightening surface of the spindle.
Use the tool and tighten the spindles.
• Tightening the spindles in a clockwise direction increases the
pressure of the rollers on the crop.
• Tightening the spindles in an anticlockwise direction reduces the
pressure of the rollers on the crop.
It is recommended that the springs be adjusted approximately 5 mm
(
3
/
16
’’) at a time, after which the pressure of the rollers on the crops
should be tested.
Tightening surface
Tightening surface
To Next Page
Loading...
