Disinfecting agents for bathing water
The Victory Spa brand producer recommends application of the following agents to maintain a clean
bath:
- A liquid bactericide for baths with hydromassage - used in baths with automatic disinfection system
(OVS-06 to Tornado SMS systems). The agent is dosed directly into water before bathing. It is
absolutely nondetrimental for human health.
- A bactericide in quickly dissolving tablets for baths with hydromassage without automatic disinfection
(OVS-01 to OVS-04 systems). The agent has to be used before each bath. It is absolutely non-
detrimental for human health.
2. Carrying out disinfection.
a) With help of antibacterium liquid for whirlpools with automatic
disinfection systems available for OVS-06, OVS-GI and OVS-GII, Sirocco,
Typhoon, Tornado, Tornado SMS systems only.
Choose of disinfection type
There are two basic type of disinfection: disinfection before the bath and disinfection after the bath.
The type of disinfection has to be choosed before filling the whirlpool in.
If we assume, that we we will use option “disinfection before bath”, then after the bath we can still use
the other option.
Disinfection before bath
After establishing the type of disinfection , and filling the bath in with water, in the moment when the
green diode is switched on the touch panel, the antibacterium agent will be automatically dosed into
water, and the blower automatiacally will start to work for about 30 second. When devices switch off, it
is possible to have a bath. That is completely safe for human health.
The green diode on the disinfection button flickers when is not enough disinfection liquid in the
chemical container.
Attention: In case of that after filling in the bath will not be bactericide in chemical container,
disinfection program will be stopped till the moment the liquid will be completed. If we don't have
enough bactricide to filling up the level of the liquid in the container, we could cancel disinfection by
pressing disinfection button for about 5 second.
Disinfection after bath
After establishing the type of disinfection should be pressed disinfection button. Into bathtubs will be
dosed disinfection agent. The pump and the blower will start to work sequential. When devices switch
off (after about 10 minutes) the bath should be emtied.
Water disinfection will be made when bacticide is in the chemical container. When there is to little
disinfection liquid in the container the green diode on the disinfection button flickers. Besides on the
screen will be shown inscription “E3”, and no function of hydromassage will be anable. The disinfection
liquid should be refilled.
b) With help of quickly dissolving antibacterial tablets for whirlpools whithout automatic disinfection
systems from system OVS-01 to OVS-04 only.
Before every bath should put into the water one tablet for one person. Then switch on hydromassage
devices for about 20 sec. After this time it is possible to have a bath.
3
ENGLISH
To Next Page
Loading...