Replacement of remote control batteries
A remote control is equipped with a 3V battery marked with the CR2032
symbol.
In order to replace the battery:
1. Remove covers from the rear part of the remote control casing.
2. Remove screws connecting remote control casing (the photo illustrates
the view of disassembled remote control).
3. Replace the battery
4. Place both parts of remote control casing together and connect them
with the screws.
5. Put on the covers of the rear part of the remote control casing.
Note! Pay attention to the appropriate arrangement of the seal in
order to maintain the remote control watertight.
The replacement of the bulb of the underwater light.
The underwater light is equipped with the bulb 35 W 12 V. In order to replace the bulb you should:
1. disconnect the tub from power
2. unscrew the safety pin from the plate
3. unscrew the plate
4. remove the glass of the lamp
5. take out o-ring
6. change the bulb
7. check if o-ring is placed properly
8. put on the glass
9. screw the plate
10. screw the safety pin
11. connect the tub to the power
Battery Cr2032
cover plate
o-ring
glass
light bulb
locking pin
5
ENGLISH
To Next Page
Loading...
