Replacement of a bulb in an underwater lighting lamp colour.
Note! Bulb replacement should be realised from the inside of the bath.
Underwater lighting lamp is equipped with a halogen bulb 35 W 12V with MR 11 symbol, lamp cap GU4.
In order to replace the lamp bulb:
? make sure that location of a fastening disc allows for accessing the bulb, i.e. whether a colour glass
does not cover the bulb. If the colour glass covers the bulb, switch on the underwater lighting and
draw the fastening disc using a switch of colour change to a position where the bulb is not covered.
? disconnect bath power supply,
? unscrew a cover plate,
? unscrew 6 screws fastening the ring,
? remove the ring, glass and sealing rings,
? unscrew a screw plug using the supplied spanner,
? remove the bulb using a suction cup and replace it,
? screw the screw plug down using the supplied spanner,
? put on sealing rings and a glass check the correctness of the sealing rings arrangement,
? screw the ring down,
? screw the cover plate down,
? connect bath power supply.
suction cup
(for bulb removal)
spanner for unscrewing
(screwing down) screw plug
cover plate
screw
ring
glass
bulb
screw plug
sealing rings
fastening disc
colour glass
6
ENGLISH
To Next Page
Loading...