WRONG LOGIN PARAMETERS
If after the login you receive the message “Wrong login parameters! Please check Server IP settings” proceed as follows depending
on if ‘Run As Server’ is selected or not:
• if it is unchecked, check the IP address settings following the procedure described on page 14;
• if it is checked, please rst proceed as described on page 15 then follow the procedure below
Fig. 56 press the home button
Fig. 57 tap on the Bit Web Server icon to launch it
Fig. 58 Web and Database servers must be switched on by tapping
on it then tap on settings to verify the “Auto Start” options
Fig. 59 tap on “General conguration”
Fig. 60 Be sure that the “Auto Start” is enabled (orange) for both
servers then press the home button again.
Fig. 61 After starting the bitweb server, tap on the concierge appli-
cation and restart it
Art.CST2220 VX2200 IP Concierge Station GUI instruction sheet