Videx VX2300 - Page 34

VX2300 2 Wire Video Digital System
PrtCode:VX2300_2_9.doc – Pag.34 08/03/2011 Rev.2.9
CONTROLS
Jumpers J4 and J2 are used to adjust the signal amplification and the termination of the main BUS (BUS-M).
J4 BUS-M Amplification
Position Amplification level
M L H
J4
Low
M L H
J4
Medium
M L H
J4
High
J2 BUS-M Termination
Position Termination
O C
J2
Disabled
O C
J2
Enabled
SPECIFICATION
Housing/Mounting
9 Module A Type DIN box / DIN Bar or directly to the wall
Push Buttons
N/A
Programming
By 8 way dip-switch
Controls Amplification (J4) and termination (J2) main bus line BUS-M
Power Supply
From specific power supply
Working Temperature
-10 +50ºC
CUSTOMER SUPPORT INFORMATION
All Countries Customers UK Customers
VIDEX Electronics S.p.A.
www.videx.it – technical@videx.it
Tel.+39 0734 631669
Fax +39 0734 632475
VIDEX Security LTD
www.videx-security.com
Tech Line 0191 224 3174
Fax 0191 224 1559
The product is CE marked demonstrating its conformity and is for distribution within all
member states of the EU with no restrictions.
This product follows the provisions of the European Directives
89/336/EEC & 92/31/EEC (EMC),
73/23/EEC (LVD) and 93/68/EEC (CE marking).
Il prodotto è marchiato CE a dimostrazione della sua conformità e può essere distribui-
to liberamente all’interno dei paesi membri dell’unione europea EU.
Questo prodotto è conforme alle direttive Europee
89/336/EEC & 92/31/EEC (EMC),
73/23/EEC (LVD) e 93/68/EEC (Marcatura CE).