Vitodens 200-W B2HA 80 to 100, 285 to 352 Installation
13
5685 827 - 14
Wall Mounting
Boiler Connections
Installing the wall mounting bracket
The Vitodens 200-W B2HA can be wall-mounted on a
concrete wall.
Note: The enclosed screws and rawl plugs are only
suitable for concrete. For other construction
materials, use bolts and anchors that are suitable
for 220 lb (100 kg) loads.
Installation of mounting bracket on brick/concrete wall
1. Drill holes 7
31
/
64
in. (12 mm).
2. Install rawl plugs and screw mounting bracket
to wall.
3. Ensure the mounting bracket is level.
CAUTION
Whichever mounting method is used, ensure that the
bracket is tightly and securely fastened to wall. Failure
to secure boiler properly could cause boiler to loosen,
posing a severe safety hazard.
Fitting the wall mounting bracket
Following are the installation instructions for the mounting
bracket on each material. See the instructions applicable
to your installation requirements.
To Next Page
Loading...
