60
13. Restart the projector.
CAUTION
Do not turn the power on with the lamp cover removed.
Resetting the lamp timer
14. After the startup logo, open the On-Screen
Display (OSD) menu.
15. Go to the SYSTEM SETUP: Advanced >
Lamp Settings menu. Press MODE/ENTER
on the projector or ENTER on the remote
control. The Lamp Settings page is
displayed.
16. Press to highlight Reset lamp timer and
press MODE/ENTER on the projector or
ENTER on the remote control. A warning
message is displayed asking if you want to
reset the lamp timer.
17. Highlight Reset and press MODE/ENTER
on the projector or ENTER on the remote
control. The lamp time will be reset to '0'.
CAUTION
Do not reset if the lamp is not new or replaced as this
could cause damage.
10. Place the lamp protection film supplied
with the new lamp on the lamp
compartment.
11. Replace the lamp cover on the
projector.
12. Tighten the screws that secure the lamp
cover.
CAUTION
• Loose screw may cause a bad connection,
which could result in malfunction.
• Do not over tighten the screws.
Reset Lamp Timer?
Reset
Cancel
Notice
Downloaded From projector-manual.com Viewsonic Manuals
To Next Page
Loading...
Need help?
General