10
Using the remote mouse control
The capability of operating your computer with the remote control gives you more
flexibility when delivering presentations.
1. Connect the projector to your PC or notebook with a USB cable prior to using the
remote control in place of your computer’s mouse. See "Connecting a computer"
on page 14 for details.
2. Set the input signal to COMPUTER.
3. Press Mouse on the remote control to switch from the normal mode to the mouse
mode. An icon appears on the screen to indicate the activation of the mouse
mode.
4. Perform the desired mouse controls on your remote control.
• To move the cursor on the screen, press / / / .
• To left-click, press .
• To right-click, press .
• To operate your display software program (on a connected PC) which responds
to page up/down commands (like Microsoft PowerPoint), press Page Up/Page
Down.
• To return to the normal mode, press Mouse again or other keys except for the
mouse related multi-function keys.
Remote control code
The projector can be assigned to 8 different remote control
codes, 1 to 8. When several adjacent projectors are in
operation at the same time, switching the remote control
codes can prevent interference from other remote
controls. Set the remote control code for the projector first
before changing that for the remote control.
To switch the code for the projector, select from among 1
to 8 in the SYSTEM SETTING: ADVANCED > Remote
Control Code menu.
To switch the code for the remote control, press ID set and the corresponding button
from 1 to 8 buttons on the remote control together for 5 seconds or more. The initial
code is set to1. When the code is switched to 8, the remote control can control every
projector.
Note
• If different codes are set on the projector and remote control, there will be no response
from the remote control. When that happens, switch the code for the remote control
again.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
