ViewSonic X1 - Projector Operation and Setup; Turning Projector On;Off; First Time Activation

24
Operation
Turning the Projector On/Off
Starting Up the Projector
1. Press the Power buon to turn on the projector.
2. The light source will light up, and a “Power On/O Ring Tone” will play.
3. The Power Indicator Light stays
green when the projector is On.
NOTE:
• If the projector is sll hot from previous use, it will run the cooling fan for 90
seconds before acvang the light source.
• To maintain light source life, once you turn the projector On, wait at least ve (5)
minutes before turning it o.
4. Turn on all of the connected equipment, i.e. notebook, and the projector will
start to search for an input source.
NOTE:
If the projector detects an input source, the Source Selecon Bar will appear. If
an input source is not detected, the message, ‘No Signal’ will appear.
First Time Activation
If the projector is activated for the first time, select the projector position, WiFi
settings and OSD language following the on-screen instructions.