ViewSonic X1 - Correcting Image Distortion

28
Correcting Keystone
Keystoning refers to the situation where the projected image becomes a trapezoid
due to angled projection.
To correct this, besides adjusting the height of the projector, you may also:
1. Use the
Left/ Right/ Up/ Down keys on the projector or remote control
to display the keystone page (when the input source is not SMART SYSTEM).
2. Aer the keystone page is displayed, press
Down to correct keystoning at
the top of the image. Press Up to correct keystoning at the boom of the
image. Press to correct keystoning at the boom of the image. Press
Right to correct keystoning at the right side of the image. Press Left to correct
keystoning at the le side of the image.
MENU
EXIT
SOURCECOLOR
MODE
?
ENTER
BLANK