ViewSonic X1 - Advanced Image Shaping and Hiding; Adjusting Image Corners

29
Adjusting 4 corners
You can manually adjusts the shape and size of an image that is unevenly
rectangular on all sides.
1. To display the Corner Adj. page, you can do
one of the followings:
• Press ENTER/OK.
• Open the OSD menu and go to the
DISPLAY > Corner Adj. menu and press
Enter. The Corner Adj. page is displayed.
Indicates the corner you seleted.
2. Use / / / to select the corner you
wish to adjust and press ENTER/OK.
3. Use
/ to select an adjustment method that suits
your need and press ENTER/OK.
4. As indicated on the screen (
/ for a 45-degree
angle adjustment and / / / for a 90-degree
angle adjustment), press / / / to adjust its
shape and size. You can press Exit or to go back
to a previous step. A long press for 2 seconds on
ENTER/OK will reset the sengs on the corner that
you chose.
NOTE:
• Adjusng keystone will reset the
Corner Adj.
sengs.
• Aer the
Corner Adj. sengs have been modied, some aspect raos or mings
are not available. When that happens, reset the sengs on all 4 corners.
Hiding the Image
In order to draw the audience’s full attention to the presenter, you can press
BLANK on the projector to hide the screen image. Press any key on the projector or
remote control to restore the image.
CAUTION:
Do not block the projecon lens as this could cause the blocking object to
become heated and deformed or even cause a re.