To Next Page

To Previous Page

IP camera management

2-Checkthecorrespondingversioncheckbox(EnableSNMPv1,EnableSNMPv2,EnableSNMPv3)accordingtotheversionoftheSNMPsoftwareyou

download.

3-Setthe“ReadSNMPCommunity”,“WriteSNMPCommunity”,“TrapAddress”,“TrapPort”andsoon.Pleasemakesurethesettingsarethesameas

thatofyourSNMPsoftware.

Note:Pleaseusethedi󰀨erentversioninaccordancewiththesecuritylevelyourequired.Thehighertheversionis,thehigherthelevelofthesecurityis.

4.5.6 - RTSP

GotoCong Network RTSP.

1-Select“Enable”.

2-RTSPPort:Accessportofthestreamingmedia.Thedefaultnumberis554.

3-RTSPAddress:TheRTSPaddressyouneedtoinputinthemediaplayer.

4-Check“Enableanonymousviewerlogin…”.

4.5.7 - UPNP

Ifyouenablethisfunction,youcanquicklyaccessthecameraviaLANandyoudon’tneedtoconguretheportmappingwhenthecameraisconnected

totheWANviatherouter.

GotoCong Network UPnP:

Select“EnableUPNP”andtheninputfriendlyname.

AfteryouenableitandsettheUPnPname,youwillseetheUPnPnamebyclicking“Network”onthedesktopofyourcomputerwhichisinthesamelocal

areanetwork.Thendoubleclickthisnametoaccessthecameraquickly.