Vingtor Stentofon ACM-M-A-V2 - Integrated PA Interface; IP Configuration

Page 16 ACM Telephone System – AMC-M-A A100K 10430 v.1.0
4.2 Integrated PA Interface
By default the system is programmed to support emergency PA
announcements (ALL CALL) initiated from analogue telephones with
group access level = 2.
Table 4 Integrated PA interface example
PA ALL CALL is accessed by dir.no. 84. The call is configured with
group access level 2 (high). Only subscribers with access level 2 can
make PA ALL CALL.
z Signal direction
- The system initiating the PA call.
z Type
Type of signal on the interface. The different types are:
- Audio
- Normal call to a zone
- Emergency call to all stations and speakers
- Digital I/O
- Mute relay (used to signal ‘mute’ to external systems such as
sirens).
z RCO
- Indicates the station associated with the remote control output.
z Terminal
- Specifies the ACM terminal block where the signal is connected.
4.3 IP Configuration
This table shows the IP configuration for the different components in the
ACM rack if applicable.
IP CONFIGURATION
Equipment Port # Note IP address Mask
ACM Eth0 Master node 169.254.1.5 255.255.255.0
ACM Eth1 Master node 10.1.0.10 255.255.255.0
Data switch - 10.1.0.50 255.255.255.0
Telephone gateway, MP-11X - 10.1.0.101 255.255.255.0
Alarm module - 10.1.0.200 255.255.255.0
DECT Server - 10.1.0.201 255.255.255.0
DECT BS-1 - 10.1.0.202 255.255.255.0
DECT BS-2 - 10.1.0.203 255.255.255.0
DECT BS-3 - 10.1.0.204 255.255.255.0
DECT BS-x - 10.1.0.204 255.255.255.0
Table 5 IP Configuration example
INTEGRATED PA INTERFACE
Signal direction Type LCM A B C D RCO Terminal Info
ACM to SPA Audio 0dB 1 8 8 LCM, J15, OUT2 Audio 8A/B for PA monitor
ACM to SPA PA - ALL CALL RCO1 LCM, 1K+,1K- S1 = Poten. free