A100K 10430 v.1.0 ACM Telephone System – AMC-M-A Page 27
6.5.2 Program different class of service for users
An ACM solution is usually programmed with the following Classes of
Service:
z COS 1 Regular stations in the system
z COS 2 Notify busy station
z COS 3 Override of absent or private feature
z COS 4 Busy override
z COS 5 Override of busy, absent and private
z COS 16 Includes all services. Default for SuperUser
Create a new Class of Service
z Click on the Class of Service icon
- The Class of Service window is opened
z Select the Class of Service you want to modify and press Change
- A window to change the selected Class of Service is opened
z Press the Copy from button and select Default
- The selected Class of Service gets the same service set as the
default station (Class of Service 1)
z Select the services you want to assign to the selected Class of
Service
z Press OK when all services are selected.
6.6 Configure Interface to PA
A normal subscriber (user) extension is used as interface from the ACM
system to the PA system. At each subscriber position the ACM has a
remote control output, where RCO1 is at subscriber position 1 and so
on. The RCO is used to signal PTT and muting of GA during emergency
PA to the PA system.
z Press User and Stations icon
z Select the subscriber position used as interface to the PA system
In ACM-M-A-V2 physical no. 8 is used.
z Press Events
z Press Insert
z Select Event Type to Audio
z Press the Detail button
z Select Voice Paging
z Press OK
z Select RCO1 to be used to control PTT
z Press OK
6.7 Configure External Communication
See the A100K 10333 - SIP Gateway AudioCodes MP-114/118 manual
for information on how to program and configure external
communication.
Figure 26 COS feature selection
To Next Page
Loading...