Vingtor Stentofon ACM-M-A-V2 - Enter License Key

Page 24 ACM Telephone System – AMC-M-A A100K 10430 v.1.0
Set IP gateway (router)
Route type ‘Host’ is used to set up a route to a single device outside the
subnet of the AlphaCom.
Route type ‘Net’ is used to set up a route to another network.
Route type ‘Default’ is used to set up a general route to any device
outside the subnet of the AlphaCom.
z Select System Configuration > Routes
z Select type of IP route
- default IP route, specific IP route or specific host route
z Default IP route.
Enter only gateway (IP address) and Ethernet port (Eth0/1)
z Network route.
Enter destination IP address, network mask, gateway and Ethernet
port
z Host route.
Enter IP address, gateway and Ethernet port
z Save and Apply changes
6.4 Enter License Key
z Obtain license key from your ACM distributor.
z Select System Configuration > License Key
z Enter the key string under New License Key
z Press the Insert new license key button to install this license.
The license configuration is shown on top of the page.
Note! The ACM-M-A-V2 requires IP station license and SIP trunk licenses
for the number of IP stations and analogue telephone trunks the
exchange shall support.
Figure 24 AlphaWeb License Manager