Vingtor Stentofon ACM-M-A-V2 - Configure IP Address

A100K 10430 v.1.0 ACM Telephone System – AMC-M-A Page 23
6.3 Configure IP Address
To connect the AlphaCom E to your IP
network, you need to enter the IP settings for
the Ethernet ports and IP route entries
according to the network. See Chapter 4.3
ACM Programming and Cable Reference List
for IP settings to use.
Set IP address for Ethernet port 0 and/or 1
• Log in to AlphaWeb
• Select System Configuration >
Interfaces
• Enter IP address
• Enter subnet mask
• Save and Apply changes
Figure 22 AlphaWeb IP Routes
Figure 21 AlphaWeb IP interface address setting